[Winding a Mechanical Watch]:
1. For most standard crowns, simply rotate the crown forward (clockwise) without pulling it out to wind the watch; if the watch is new and lacks power, wind it about 30 to 40 turns.
2. If the watch has a screw-down crown (common on models from brands like Rolex, Omega, and Longines), first rotate the crown counter-clockwise to unscrew it; once released, proceed with the winding method described in step
1.Important Notes
[Precautions for Mechanical Watches]: If a mechanical watch runs out of power, simply wind it manually; do not pick up the watch and shake or swing it. Many people mistakenly believe this winds the watch, but it can actually damage the movement and easily cause issues like the watch stopping intermittently or the hands getting stuck. Therefore, if the watch lacks power, just wind it normally. According to standard recommendations: wear the mechanical watch for at least eight consecutive hours during the day to maintain sufficient power, and wind it 20 to 30 turns before going to bed (which takes only about ten seconds). This ensures the watch keeps accurate time by the next morning, even if it wasn’t worn while you slept.
[Adjustment/Testing] Set the watch to the correct time and leave it sitting for three to four hours; if it keeps accurate time, then there is no issue.
To wind the watch, you must either pull the crown out or—depending on the model—rotate it clockwise while it is in its resting position against the case. First, check the crown’s status: for standard manual-wind mechanical watches, simply rotate the crown clockwise while it is flush against the case; if the watch features a screw-down crown, you must first rotate it counter-clockwise to unscrew and release it. Next, wind the watch: grasp the crown between your thumb and index finger and rotate it clockwise (usually by pushing it upward or forward), feeling for the resistance to gradually increase. Control the number of turns: generally, a manual-wind watch requires about 20 to 30 turns to reach full wind; stop winding when you feel significant resistance or the crown becomes difficult to turn—do not force it, as this could damage the internal mainspring. Finally, return the crown to its original position: if you unscrewed a screw-down crown, press it inward while rotating it clockwise to tighten it and ensure water resistance.
